Mitsubishi CS-35707 Owner's g Manual page 82

Troubleshooting (cont.)
Problems Possible Solutions
For More Information
The remote control doesn't
work.
Check that the batteries are
installed correctly.
Check that the select switch
is set to "TV."
Be sure that you are
pointing the tip of the
remote control toward the
TV from a distance of no
more than 20 feet.
See "Getting ready to use
the remote contr,_l" in
Chapter i for an explanation
of h._w to install batteries in
the remote contr,_l.
See "Remote control buttons
and functions" in Chapter 1,
which explains where the
select buttons are located.
See "Getting ready to use
the remote control" in
Chapter 1, which contains
poirLters for using the remote
control.
The TV takes several
seconds to respond to button
commands.
• Use the ENTER button to
avoid delays.
See "Changing channels" in
Chapter 3, which explains
tl=LeCunction of the ENTER
button.
You can't access a channel.
Be sure that the channel you
want to xdew is programmed
into memory.
Check that the TV is tuned
to the correct input source
(antenna) for that channel.
See "Memorizing channels"
in Chapter 3, which explains
how to program channels
into the TV's memory.
See "Selecting the input
scm'ce" in Chapter 3, which
e_:plains how to change the
input source.
• You can't see a different
channel in the reduced PIP
image.
• Use the PIP and INPUT
button to change the source
of the PIP image.
° See "Using the Picture-in-
Picture (PIP) Modes" in
Chapter 4.
The television appears to be
locked and you cannot
access any of the TV's
functions.
• Use the TIMER RESET
button to reset the TV.
See "Overview of the control
panel" in Chapter 1.
86 Chapter 5: Troubleshooting