Glossary - Philips VRX344AT Owner's Manual

52 Glossary
oQto_o oo oe leoeeei oeoJolooetoe_ J looJe oeoJo oeeoooe ooooo oeooo ooooeol leot ooe I_olo ol I_o Jool ooo_e oo ooeoe eoe • • • • oooJl •
AUDIO INIOUT Jacks: jacks located on the front and back of
theVCR which are used to record audio from another source
(IN) or to send audio to another source (OUT).
Automatic Channel Programming: process in which theVCR
scans all available channels and places the ones you receive in its
memory.Then, when you push the CHANNEL (Up/Down) but-
tons, you only scan through channels you receive.
settings that allow you to tune channels.
• Antenna-VHF (very high frequency; channels 2 - 13) and UHF
(ultra high frequency; channels 14 - 69).
• Cable - all standard channels can be received without a Cable
Box.
Cable Box/DSS Receiver Output Channel: Channel 03 or
04.
Dubbing: copying a tape using a second VCR.
Frame: a single still picture.
high quality;a feature in the VCR circuitry which provides
enhanced picture detail.
Line Input: The channel to which you set yourVCR during dub-
bing.The line input channel is always channel 001 (AV REAR) or
002 (AV FRONT).
If you accidentally enter Line Input mode (AV REAR or AV
FRONT will appear on yourTV screen briefly), press the CHAN-
NEl. (Up/Down) buttons or use the Number buttons to select
another channel.
aVCR operation.
OTR: one touch recording; programming a timed recording that
starts immediately and records for 30 minutes to eight hours,
whichever you specify.
Remote Control: the small electronic unit that came with your
VCR; allows you to operate yourVCR from a distance.You may be
able to operate yourTV, Cable Box or Digital Satellite System with
the remote control.
RF coaxial cable: The cable supplied with your VCR. Use it to
connect yourVCR to yourTV (or Cable Box/DSS Receiver, if
applicable).The supplied cable is a snap-on type. However, you may
also use a screw-on type if you prefer.
Special Effects: forward and reverse searching; viewing a still pic-
ture; slow motion.
Tape Speeds: how fast the tape travels during a recording.
• SP (standard play) - fastest tape speed (recording time for a
T I20 tape is approximately two hours); best picture quality.
• LP (long play) - average tape speed (recording time for aTI20
tape is approximately four hours).
• SLP (super long play) - slowest tape speed (recording time for
aT120 tape is approximately six hours).
VCR: video cassette recorder.
VIDEO INIOUT lacks: jacks located on the front and back of
the VCR which are used to record video from another source
(IN) or send video to another source (OUT).