Setting T Heremote To Operate A Cable Box/Digital Satellite S Ystem 21 - Philips VRX344AT Owner's Manual

Setting t heRemote to Operate a Cable Box/Digital Satellite S ystem 21
YourVCR remote control may operate your Cable Box or Digital
Satellite System. If the remote control doesn't operate your Cable
Box or Satellite System now, follow the steps below to program
your remote control.
I
Point the remote control at your Cable Box or Satellite System and
press the CBL/DSS button.Then, press the POWER button.
If your Cable Box or Satellite System turns on or off, try the other
Cable Box/Satellite System buttons (see pages 22 - 24 for details). If
your Cable Box or Satellite System doesn't turn on or off, or if the
other buttons don't work, go to step 2.
2
Find the brand of your Cable Box or Satellite System on
the list below, and remember the two-digit number to the
right of it.
CABLE BOX CODES
HAMLIN ......... 21, 22 PIONEER ....... 11, 12
JERROLD .... 01, 02, 03, SCIENTIFIC
......... 04, 05, 06, 07 ATLANTA ..... 08, 09, 10
OAK ......... 16, 17, 18 TOCOM ...... 23, 24, 25
PANASONIC ..... 19, 20 ZENITH ...... 13, 14, 15
SATELLITE SYSTEM CODES
MAGNAVOX ...... 26, 27 RCA .............. 28
3
Press and release the MUTE button.
4
Within 30 seconds after releasing the MUTE button, press and
release the CBL/DSS button.
5
Within 30 seconds after releasing the CBL/DSS button, use the
Number buttons to enter the two-digit code for your Cable
Box or Satellite System. For example, if you have a Zenith Cable
Box, press Number buttons I, 3.
6
Try step I again. If the remote control works your Cable Box
or Satellite System, you're finished. If the remote control still does-
n't work your Cable Box or Satellite System, repeat steps 2 - 5,
using a different code.
1&6
There is no guarantee that the
remote control will work your Cable
Box or Satellite System.
Find your
cable box
or satel-
lite sys-
_1tern code.
5
PHILIPS
4
3
elpfu!_Hmts
• A/though the remote control that
comes with your VCR will work most
Cable Boxesand Satellite Systems,it
is possible that the remote control will
not operate your Cable Box or
Satellite System.
The remote control may only operate
some features of your Cable Box or
Satellite System.For example, some
Cable Boxesmay only be turned on
at the Cable Box,therefore the
remote control will not be able to
turn on the Cable Box.
If you can not change the channels
at the Cable Box by using the
Number buttons, press the VCR
PLUS+/ENTER button after you
press the Number buttons. It may
change channels at the Cable Box.
If you had to program the remote
control to operate your Cable Box or
• Satellite System here, whenever you
replace the batteries in the remote
control, you will have to program the
remote control again.