Turning On Yourvcr - Philips VRX344AT Owner's Manual

Turning o nYour V CR I I
ee e• e• e• • •l e• •ee• •o• ee Jl eo• •• o• •• •ol • • Jeoo• eee• •• •• •• •• •• •e• o• Je• o• e• •o • •• .o •i • e• .o• •e •o •• • •l e• e• •• •e• •• ee •• •• •
Before turning on yourVCR, make sure there are batteries in the _ Turn on the'l_.
remote control and theVCR and TV are connected correctly.
L
• Follow the steps on this page only when you plug theVCR
i
power cord into the wall outlet for the first time. el
• You may not be able to program channels at step 5 if you are
I
using a Cable Box.
I
Press theVCR button, then the POWER button. TheVCR
light and the PWR. (power) light will appear on the display panel.
2
Turn on theTV at theTV. Set it to the same channel as
the CH31CH4 switch on the back of theVCR. The language
select display screen shown below will appear. (If the displaydoes
not appear, check your hookups, then follow the steps on page 12 to
program channels and page 19 to select a language.)
oN
KE SELECTION OR
SH MENU TO CONTINUE
3
Press the Number I button to select English on-screen dis-
plays. ON will appear to the right of ENGLISH on-screen. Or,
press the Number 2 button for Spanish on-screen displays. SI
will appear to the right of ESPAI_IOL on-screen.
4
Press the MENU button. The channel program display shown
below will appear.The display will disappear after about 60 sec-
onds if you do not press any buttons.
CR
HEN . . .
SH CH UP KEY
5
Press the CHANNEL (Up) button to begin automatic
channel programming. AUTO SET PROCEEDING PLEASE
WAIT will appear on-screen.TheVCR will place all of the channels
you receive into its memory, so when you scan through channels
using the CHANNEL (Up/Down) buttons, you'll only scan through
channels that you receive.When all channels are programmed,
CHANNELS ARE SET will appear on-screen briefly.Then the TV
will go to the lowest channel programmed.
PHILIPS
4
5
• To skip this feature and play a tape
immediately, insert a tape with its
record tab removed. Or, to skip step
3, press the MENU button. All on-
screen displays will be in English.To
skip step 5, press the STOPbutton.
Channels will not be programmed,
and CHANNELS NOT SETwill
appear on-screen.
• If you try to program channels
when there is no antenna or cable
connected to the VCR, programming
will appear to take place, but even-
tually a NO TVSIGNALS message
will appear on-screen. Connect an
antenna or cable to the VCR's
ANT(enna) IN Jack and'try again.
Youmay need to follow the steps on
page 12.
• When the clock is not set, :
will appear on the display panel.