Setting Up The Vcr Plus+ Programming System - Philips VRX344AT Owner's Manual

Setting U ptheVCR Plus+ Programming System (cont'd) 3 9
oo,, o,Q,,oe,,o,J ,o ,,o, o, • • •= ,o•o .coo ,l•,,••,.eeoo, leo,o•,,.•,Q., , • • • o.Q,o • o• oooeltleeeojeeoeloJooioeoleolee• • • •
2 2 Examine the _ists Onpage 38.
Now, compare the channel numbers you havewritten in theVCR
PLUS+CH. and CABLE/TV CH. columns.You'll notice that some
stations haveVCR Plus+ and CablefTV channel numbers that are
the same,and other stations have channel numbers that do not
match.Where the channel numbers DO NOT match, you must tell
the VCR the VCR Plus+ and Cable/TV channel numbers according
to the following steps.
• Make each entry within 60 seconds of the previous entry.
3
Press theVCR button, then press the MENU button.
4
I REPEAT PLAY OFF
2 ON SCREEN MODE
3 LANGUAGE
4 VCR PLUS+ REE MAP
1
Press the Number 2 button to selectVCR SET UP.
SrLECr PUSHNO.SHOWN
J
END PUSH EXIT 5
Press the Number 4 button to selectVCR PLUS+ REEMAP.
3
4
/_CR PLUS+ CROSS REF.MAP 1
2 ..... 2
TO SELECT CH PUSH CH UP/
DOWN THEN ENTER CH NO.
"_END PUSH EXIT
6
Look at the lists you filled in on page 38. For stations whose
VCR Plus+ and CablelTV channels do not match, press
the CHANNEL (Up/Down) buttons until the arrow is
beside the VCR Plus+ channel you need.Then, press the
Number buttons to enter the corresponding Cable/TV
channel from your list. (Enter a "0" before single-digit channels.)
Continue this process until you have entered all the stations on
your' list.
fV¢CR PLUS+ CROSS REE MAP 1
99 99
I ..... > 23
2 2
i TO SELECT CH PU,_;HCH UP/
\ DOWNTHEN ENTER CH NO.
O END PUSH EXIT
7
Press the STATUSIEXIT button to exit.
• To correct a CablelTV channel num-
ber, repeat the steps on this page.
• To clear a CablelTV channel number,
repeat steps 3-5 on this page.Then,
press the CHANNEL (Up/Down)
buttons to select it.Then press the
CLEAR button. Press the
STATUS/EXIT button to exit.
• Always enter a "0" before single-digit
channels.
• To select line input for the Cable/TV
channel, press O,0.AUX will appear
on-screen.
• When you receive theVCR from the
factory, all the VCR Plus+ channel
numbers and Cable/TV channel
numbers are the same.