Diskette Drive Removal
Remove the diskette drive as follows.
1. Remove the system unit bottom cover (see "Bottom Cover Removal").
2. Remove the four screws securing the diskette drive to the support plate (see
the following figure). Hold the drive in place and perform step 3.
3. While holding the diskette drive, move it out enough to carefully unplug the
diskette drive interface cable from its connector on the system board.
A – Diskette Drive
B – Interface Cable Connector
C – Interface Cable
4. Remove the diskette drive from the system unit.
Removing the Diskette Drive
D – Support Plate
E – Screws (4)
Disassembly and Reassembly 3-9