Installing Partitionmagic; Installing Bootmagic In A System With Windows Nt - NEC PowerMate 2000 Series Service And Reference Manual

Installing PartitionMagic

Install PartitionMagic™ files from the NEC Application and Driver CD. Select
the PartitionMagic software from the Applications tab in the Installation utility
menu. The utility loads files from the NEC Application and Driver CD to
C:\Program Files\PowerQuest\PartitionMagic4
documentation files in the following folders:
!
Btmagic
!
Diskette
!
Setup
!
Userinfo.
If the PartitionMagic setup program asks you for a serial number, enter the
following number:
PM400ENOEMCD-673785
See the documentation in the Userinfo folder for information about using
PartitionMagic, BootMagic™, and the recovery diskette program. Reading the
Userinfo files requires Adobe
on the NEC Application and Driver CD.
Note:
the Windows NT operating system, see the next section,

"Installing BootMagic in a System with Windows NT."

Installing BootMagic in a System with Windows NT
BootMagic™ is a utility included in the PowerQuest PartitionMagic™ software.
See the previous section, "Installing PartitionMagic," for general installation
information.
If you have a Windows NT operating system, use the information in the
following section to correctly configure BootMagic.
If you already installed BootMagic and the configuration resulted in an error
message, see "Correcting the BootMagic Configuration."
Configuring BootMagic
If you have a system with the Windows NT operating system, use the following
procedure to correctly configure BootMagic.
1. Follow the instructions in the PartitionMagic Userinfo folder to install
BootMagic. When the "BootMagic Configuration" box appears at the end of
the installation, continue to the next step.
®
Acrobat
If you are installing BootMagic in a system with
PowerMate 2000 Series Release Notes A-5
. You can find setup and
®
Reader. Adobe Acrobat Reader comes