NEC PowerMate 2000 Series Service And Reference Manual page 145

2. Configure BootMagic.
!
If you want to use BootMagic:
Click the
during the next bootup sequence and lets you select Windows NT as the
operating system.
!
If you do not want to use BootMagic:
Do not select the
does not appear at bootup.
3. Select
configuration process. Either choice, to enable BootMagic or to not enable
BootMagic, requires the SAVE/EXIT selection.
To correctly complete the BootMagic configuration, you must
select SAVE/EXIT from the BootMagic Configuration box,
even if you do not want to use BootMagic. Omitting this step
results in an error message.
Correcting the BootMagic Configuration
If you installed BootMagic in a system with the Windows NT operating system
and the installation resulted in an error message, use the following procedure to
correct the configuration information.
1. In the Windows Start menu, select
and BootMagic Configuration
Nothing should be listed under the MENU NAME heading in the center of
the box.
2. Click
ADD
listed and it is already highlighted.
3. Click
OK
appears with "Windows NT" listed under MENU NAME.
4. Check the BootMagic configuration.
!
If you want to use BootMagic:
Click the
during the next bootup sequence and lets you select Windows NT as the
operating system.
!
If you do not want to use BootMagic:
Do not select the
does not appear at bootup.
A-6 PowerMate 2000 Series Release Notes
ENABLE BOOTMAGIC
ENABLE BOOTMAGIC
SAVE/EXIT in the BootMagic Configuration box to complete the
. The "Bootmagic Add OS" box appears. This is the only option
. Click OK again. The main BootMagic Configuration screen
ENABLE BOOTMAGIC
ENABLE BOOTMAGIC
button. The BootMagic menu appears
button. The BootMagic menu
Programs , PowerQuest BootMagic
. The BootMagic Configuration box appears.
button. The BootMagic menu appears
button. The BootMagic menu
,