Installing The Lcd Panel - NEC PowerMate 2000 Series Service And Reference Manual

4. Carefully pull the LCD panel out of its mount on top of the system unit
chassis.
5. Carefully pull the interface cable and switch cable through the collar in the
system unit chassis. Set the LCD panel down on a clean, flat surface.
6. Install the LCD panel as follows.
!
Align the collar inside the system unit chassis so that the collar tab is
pointing toward the power switch.
!
From the outside of the system unit chassis, insert the LCD panel cables
through the chassis collar.
!
Align the three guide pins on the LCD panel collar with the guide pin
holes in the LCD mount on the outside of the chassis (see the following
figure).
!
Insert the LCD panel stem into the LCD mount on the outside of the
chassis. Ensure that the guide pins are in the pin holes.
!
Check that the LCD panel stem is fully seated in the chassis mount.
!
Secure the LCD panel to the system unit with the four previously
removed screws.

Installing the LCD Panel

A – LCD Panel Collar
B – Guide Pins (2 of 3)
C – Guide Pin Holes (3)
D – Chassis Collar
E – LCD Mount
Disassembly and Reassembly 3-21