Removing An Msm Option Card - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Installing BlackDiamond 8800 Series Module Options

Removing an MSM Option Card

To remove an option card from an MSM-48c module:
1 Attach an ESD-preventive wrist strap to your bare wrist. If the metal end is not already connected,
connect it to the ground receptacle at the top left corner of the chassis.
2 Remove the MSM from the BlackDiamond 8800 series switch as described in
BlackDiamond 8800 Series Module" on page
3 At the back of the option card, loosen the spring-loaded captive retaining screws until they pop up
(see Figure
4 At the edge of the module, rotate the hot-swap prevention latch up and hold it out of the way.
Figure 76: Removing an Option Card
5 Using the handle on the option card, pull straight back from the MSM to disconnect the option card
from the connectors on the MSM.
6 Slide the option card out of the MSM and immediately place it into anti-static packaging.
7 If you are installing a replacement option card, install the option card as described in
Option Card in the MSM-48c" on page
If you are not installing a replacement option card, install the option slot cover plate over the option
card slot.
8 Re-install the MSM, as described in
124
76).
Option card
109.
Loosen retaining
screws
122.
"Installing a BlackDiamond 8800 Series Module" on page
BlackDiamond 8800 Series Switches Hardware Installation Guide
"Removing a
MSM48c_remove_opt_card
"Installing an
102.