Denon DVD-900 Operating Instructions Manual page 12

DIGITAL OUT
_CM/BI'TSrREAM)
COMPONENT S-VIDEO
VIDEOOUT ' OUT
O
3 4 5
6
1. DIGITAL OUT JACKS:
Use eilher an optical or coaxial digital cable to connect to a compatible Dolby Digital receiver. Use to
connect to a Dolby Digital decoder or DTS decoder,
2. AUDIO OUT JACKS
Connect to the Audio input jacks of A/V-compatible TV or wide screen TV, Stereo system,
3. VIDEO OUT JACK
Use a video cable to connect one of the jack to Video input on your A/V-compatible TV or wide screen
TV, Stereo system,
4. COMPONENT VIDEO OUT JACKS
Use these jacks if you have a TV with Component Video in jacks. These jacks provide C_, CB and Y video,
ALong wilh S-Video, Component Video provides the best picture quality;
5. S-VIDEO OUT JACK
Use the SWideo cable to connect this jack to the S-Video jack on your A/V-compatible TV or wide screen
TV fnr a higher quality picture.
6. PROGRESSIVE switch
Selecting Progressive Scan (480p
or Interlaced
4800 Playback
• If your TV is compatible with progressive scanning (480p), connect the TV to Ihe Component Video Output
jacks of the DVD player and set the Progressive switch on the back of the DVD player to "PROGRESSIVE".
Next, set your TV to the progressive scan mode.
If your TV is not compa/ible wilh progressive scan, keep the Progressive switch to "INTERRACE".
• Use a commercially available adaptor if the video input jacks of your TVs or monitors are the BNC type,
What is Progressive Scanning?
• Unlike conventional interlace scanning, the progressive scan system provides less flickering and images in
higher resolution than that of traditional (480i) lelevision signals,
The DCDi (Directional Correlational De-interlacing) system of this DVD player produces smooth and
natural video images, even if really dynamic, by eliminating the jagged edges, "DCDi" is a registered
trademark of Faroudja, a division of Sage lnc,
12