Button Fitting With Thread Shank - Brother VX-1120 Operation Manual

Button Fitting with Thread Shank
The thread shank of a button _s o_tenneeded when
sewing on heavier fabric.
1. Place a button between _e _resset foot and the
mater,S, adjust the st_ch wi_h according to the
distance between the holes in the button and sew
on the button as previously expf_ned.
2, After sewing about 10 stitches, remove the fabric
from the mechtne leaving a tonger upper thread
(about 15 cm (6")) }n Orderto fo_ ethread shank;
3. Putl the upper thread through one of the holes on
the button until it is between the button and the
materia{ and tightly wrap the thread around the
stitches.
4, With a corrnai sewing h_le; pull the threads to
the back of the material and tie the ends togethe_
to secure the button.
Pate crest una can/lie de bile en el bot6n
S_se cose en tejidos rods g_esos, es cenveniente
baser una can/Its de h/to en toe botones,
I_ Cotoque el bot6n entre el orensatetas y e! teJldo.
ajuste al aneho de puntada de acuerdo con la
dtstancia existente entre los d/st/rites agu]eros
del bot6n y cosa el botan ta! come ae indic5
antefiormente.
2. Deepu_s de eoser unae 10 puntadas, retire el
tejido de la m_qutna dejando que sebre un h/to
superior m,_s largo tunes 15 cm o 6") pare poder
former la can/tie=
3. Pase el hire superior per une de k_ agujerco dal
betan haste que se encoentre entre el te]ide y el
bet6n y d_ unas vueltas cerradae afrededor de /as
puntadas
4. Con una aguja de coser normal, tire los h/los per
et rev(_e de/tejido y anude toe extrernos juntos
pare asegurar et bot6n.
33