Removing The Front Brake Cable; Removing The Front Brake Assembly; Adjusting The Front Brake - APRILIA Enjoy City Workshop Manual

Enjoy

REMOVING THE FRONT BRAKE CABLE

Read through the section PRECAUTIONS AND
GENERAL INFORMATION.
1
Put the vehicle on the stand.
Turn the power switch to OFF.
Detach cable guide tube (1), which is anchored to
brake arm (2), after manually bringing the brake unit
into braking position.
2
3
Loosen screw (3) to allow the cable to be removed.
Align the slotted holes on adjusters (4) of the front
7
brake control body. 4
Remove sheath (5) to allow the cable of front brake
lever (6) to be released after closing it.
Remove cable (7).
5
6
REMOVING THE FRONT BRAKE
ASSEMBLY
Read through the section PRECAUTIONS AND
GENERAL INFORMATION.
2
2
Put the vehicle on the stand.
Turn the power switch to OFF.
Remove the cable from the assembly as described in the
paragraph REMOVING THE FRONT BRAKE CABLE.
1
Loosen and remove the two screws (1) so as to
1
disengage and remove the two arms (2) from the
braking assembly.

ADJUSTING THE FRONT BRAKE

2
1
Read through the section PRECAUTIONS AND
GENERAL INFORMATION.
Put the vehicle on the stand.
Turn the power switch to OFF.
Lever adjustment.
Loosen adjuster (1).
Rotate adjuster (2) clockwise to increase the travel of
lever (3).
Rotate adjuster (2) anticlockwise to decrease the
travel of lever (3).
3
After obtaining the desired adjustment, tighten ad-
juster (1).
40
Release 00 2000-11