Table of Contents
Advertisement
9.
Hold rod with
one hand and with a 7/16
in. wrench
or
pliers start screwing
on ONE of the nuts only ,A TURN
OR TWO
...
screw on other nut the same way.
10. Using TWO
7/16
in. wrenches
or pliers tighten
both of
the nuts.
IMPORTANT:
Apply a coat of paste wax to the top surface
and front edge of the front guide bar. This will allow the
fence to slide more easily.
11. Slide the bars so that screws are in the MIDDLE of the
slotted holes.
12. Position rip fence over miter gauge groove, holding up
the rear end while engaging front end with bar ...
Iower fence onto table.
13. Raise blade all the way up.
8 THICKNESSES
of rear guide bar.
19. Move fence to RIGHT edge of table . .. make sure it is
approx. 1/32
in. above table at front and rear and
tighten screws.
8 THICKNESSES
OF
PAPER
•
10
Hide quick links:
Advertisement
Table of Contents
