Adjusting Rip Scale Pointer; Installing Blade Guard - Craftsman 113.24250 Owner's Manual

If the fence does not slide easily along the bars. the pressure
of the spring can be R EDUCED.
1. Loosen the screws.
2. Move spring slightly toward rear of fence . .. tighten
screws.
SPRING
SCREWS _
,
The rip fence must be PARALLEL with the sawblade
and Miter Gauge grooves ... Move fence until it is
along side of groove. Do NOT LOCK IT. It should be
parallel to groove. If it is not;
A. Loosen the two "Hex. Head Screws."
B. Hold fence head tightly against bar .., move end
of fence so that it is parallel with groove,
C. Alternately tighten the screws.
\\
HEX SCREWS
ADJUSTING RIP SCALE POINTER
1. Turn ELEVATION handwheel clockwise until blade is
up as high as it will go.
IMPORTANT: BLADE must be SQUARE |90o| to
TABLE, in order to ALIGN rip fence.
2. Position fence on right side of sawblade so that it
touches the sidesof the teeth.., tighten lock knob.
3. Loosen screw holding the pointer.., adjust pointer so
that is points to "0"... tighten screw.
NOTE: If you cannot adjust pointer sothat it points to
"0", loosen the screws holding the front guide bar and
move the guide bar.
:E NCE
XLOCK HANDLE _
INSTALLING BLADE GUARD
1. From amoung the loose parts, find the hardware.
2. Attach SPREADER to SPREADER SUPPORT so that
screws are all the way back in the SLOTS of SUPPO RT
... hand tighten screws,
v4-2ox 5/8 // I_
_ SI_EADER
'_ SUPPORT
EXT. I/4
I
NUT, HEX I/4
12