GE P2S975 Owner's Manual page 13

Using the clock, timer and range lock-out. GEAppliances.co
To Setthe Clock
The clock m ust beset t othe correct time ofday
for the automatic oven timing functions to work
properly, The time of day cannot be changed
during a timed baking or self-cleaning cycle.
Make sure the clock is set to the
correct time of day.
[] Touch the CLOCKpad.
[] Touch the number pads.
[] Touch the STARTpad.
_INERJ
OdOFF
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
To Set the Timer
FT] Touch the KITCHENTIMERON/OFF pad.
Touch the number pads until the amount
of time you want shows in the display. For
example, to set 2 hours and 45 minutes,
touch 2,4 and 5 in that order. If you
make a mistake touch the KITCHEN
TIMERON/OFF pad and begin again.
r_ Touch the STARTpad.
After touching the STARTpad, SETdisappears;
this tells you the time is counting down,
although the display does not change until one
minute has passed.Seconds will not be shown
in the display until the last minute is counting
down.
%
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the KITCHENTIMER
ON/OFF pad istouched.
The 6-second tone can be canceled by
following the steps in the Specialfeatures of
your oven control section under Tones at the
End of a Timed Cycle.
To Reset the Timer
If the display is still showing the time remaining,
you may change it by touching the KITCHEN
TIMERON/OFF pad, then touch the number
pads until the time you want appears in the
display.
If the remaining time is not in the display
(clock, delay start or cooking time are in the
display), recall the remaining time by touching
the KITCHENTIMERON/OFF pad and then
touching the number pads to enter the new
time you want.
To Cancel the Timer
Touch the KITCHENTIMERON/OFF pad twice.
[[ RANGE
]
IILOCK-OUT|
[ HoLo3 SECONOS I
Range Lock-Out ton some models)
Your control will allow you to lock out the
surface burners, oven burners and control
panel so they cannot be activated.
To lock/unlock the controls:
%
@
Turn all surface burners off.
Touch and hold the RANGE LOCK-OUT
pad for 3 seconds until the display shows
LOC ON.
To unlock the control, touch and hold the
RANGE LOCK-OUT pad for 3 seconds until
the display shows LOC OFF.
When this feature is on and the touch pads are
touched, the control will beep and the display
will show LOCON.
The control lock-out mode affects all
controls. No controls will work when this
feature is activated.
The adjustment will be retained in memory
after a power failure.
13