Nvidia ForceWare Software User's Manual page 34

C 2
HAPTER
Setting Up Your RAID Configuration
Windows Setup
Enter=Select
Figure 2.20
b Select "NVIDIA RAID CLASS DRIVER (required)" and then press Enter.
c Press S again at the Specify Devices screen, then press Enter.
d Select "NVIDIA NForce Storage Controller (required)" and then press Enter.
The following Windows Setup screen appears listing both drivers:.
Windows Setup
S=Specify Additional Devices
Figure 2.21
5 Press Enter to continue with Windows XP Installation.
30
The following Windows Setup screen appears:
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to resutrn to the previous screen.
NVIDIA RAID CLASS DRIVER (required)
NVIDIA NForce Storage Controller (required)
F3=Exit
Windows Setup—Select SCSI Adapter
Setup will load support for the following mass storage device:
NVIDIA RAID CLASS DRIVER
NVIDIA NForce Storage Controller
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Windows Setup—NVIDIA drivers listed
ENTER=Continue F3=Exit
MediaShield User's Guide – Version 4.0