Table of Contents
Advertisement
Synchronizing a RAID Array
Synchronizing an array will force a rebuild of redundancy or parity. The operation is
applicable to any fault tolerant array such as RAID 1, 0+1 and RAID 5.
• For RAID1 and RAID 0+1, "sync" results in copying the data to the redundancy disk,
• For RAID 5, "sync" results in rebuilding the parity
To sync an array, do the following (This example assumes you have already created a
fault tolerant array such as RAID 1):
1 Right click on "Mirroring" and select Synchronize Array as shown in
Figure 4.15
The Synchronize Array Wizard Welcome screen appears.
NVIDIA Corporation
Array Pop-up Menu
Initializing, Rebuilding, and Synchronizing RAID Arrays
C
4
HAPTER
Figure
4.15.
137
Advertisement
Table of Contents
