A smaller wire gauge size has greater capacity
than a larger number (14-gauge
wire has more capacity
than 16-gauge
wire; 12-gauge wire has more capac-
ity than 14-gauge).
When in doubt, use the smaller number. When operating
a power tool outdoors,
use an outdoor
extension
cord marked "W-A" or "W".
These cords are rated for outdoor
use and reduce the risk of electric shock.
,_
CAUTION:
Keep the extension
cord clear of the working
area. Position the
cord so that it will not get caught on lumber, tools, or other obstructions
while
you are working
with a power tool.
,_
WARNING:
Check extension
cords before each use. If damaged,
replace
immediately.
Never use a tool with a damaged
cord, since touching
the damaged
area could cause electrical
shock, resulting
in serious injury.
SAFETY SYMBOLS
FOR YOUR TOOL
The label on your tool may include the following symbols.
V ......................................................
Volts
A.......................................................
Amps
Hz .....................................................
Hertz
W. .....................................................
Watts
min ...................................................
Minutes
"%'
...............................................
Alternating
current
---=
..............................................
Direct current
no
................................................
No-load speed
[]
..................................................
Class II construction,
Double Insulated
.../min ...............................................
Revolutions
or Strokes per minute
..............................................
Indicates danger, warning or caution.
It means
attention? Your safety is involved.
SERVICE SAFETY
•
If any part of this router is missing or should
break, bend, or fail in any way;
or should any electrical
component
fail to perform
properly:
shut off the
power switch, remove the router plug from the power source, and have the
missing,
damaged
or failed parts replaced
before resuming operation.
•
Tool service
must be performed
only at a Craftsman
Parts and Repair
Center. Service or maintenance
performed
by unqualified
personnel could
result in a risk of injury.
•
Use only identical
replacement
parts when servicing
a tool. Follow the
instructions
in the maintenance
section of this manual. Use of unauthorized
parts or failure to follow maintenance
instructions
may create a risk of electric
shock or injury.
28084 Manual Revised 07-0712
Page 7