Table of Contents
Advertisement
•
Extension
cords lO0-ft, or longer are not recommended.
•
A smaller wire gauge size has greater
capacity
than a larger number
(14-gauge
wire has more capacity
than 16-gauge wire; 12-gauge wire has
more capacity
than 14-gauge).
When in doubt use the smaller number. When
operating
a power tool outdoors,
use an outdoor
extension
cord marked
"W-A" or "W". These cords are rated for outdoor
use and reduce the risk of
electric
shock.
_,
CAUTION:
Keep the extension
cord clear of the working
area. Position the
cord so that it will not get caught on lumber, tools, or other obstructions
while
you are working
with a power tool.
_,
WARNING:
Check extension
cords before each use. If damaged,
replace
them immediately.
Never use a tool with a damaged
cord, since touching
the
damaged
area could cause electrical
shock,
resulting in serious injury.
SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following symbols.
V ...................................................... Volts
A....................................................... Amps
Hz ..................................................... Hertz
W...................................................... Watts
min................................................... Minutes
............................................... Alternating current
.................................................
Direct current
no
................................................ No-load speed
[]
.................................................. Class II construction, Double Insulated
.../min ............................................... Revolutions or Strokes per minute
.............................................. Indicates danger, warning or caution. It means
attention! Your safety is involved.
SERVICE
SAFETY
If any part of this router is missing or should break,
bend, or fail in any
way; or should any electrical
component
fail to perform
properly:
shut off the
power switch and remove the router plug from the power source and have the
missing,
damaged,
or failed parts replaced
before resuming operation.
Tool service
must be performed
only at a Craftsman
Parts and Repair
Center. Service or maintenance
performed
by unqualified
personnel
could
result in a risk of injury.
28212 Manual_Revised_07-0713
Page 7
Advertisement
Table of Contents
