Craftsman 320.28084 Product Manual page 50

4. When the desired depth
of cut is set, tighten the
clamping lever.
The precise depth of cut can
be measured with a ruler.
When using the plunge base
to attach the router to the
router table, the bit depth
can be adjusted by turning
the depth rod clockwise or
counterclockwise with the
wrench supplied (Fig. 37b).
1. Turn off the router.
Fig. 37b
2. Lock the Plunge Depth Locking Lever.
3. Insert the wrench into the adjusting hole on the tabletop. Turn the depth
rod on the router clockwise with the wrench to move the collet/nut up, or
counterclockwise to move the collet/nut down.
4. When the desired depth of cut is set, tighten the clamping lever.
The precise depth of cut can be measured with a ruler
28084 ManuaLRevised 07-0712 Page 50