Unpacking - Craftsman 320.28084 Product Manual

• Inspect tool cords periodically and, if they are damaged, have them repaired
at your nearest Craftsman Service Center. Be aware of the cord location.
• Always check the tool for damaged parts. Before further use of the
tool, a guard or other part that is damaged should be carefully checked to
determine if it will operate properly and perform its intended function. Check
for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the tool's operation. A guard or other part that is
damaged should be properly repaired or replaced at a Sears Service Center.
- Inspect and remove all nails from lumber before routing.
,, Save these instructions. Refer to them frequently and use them to instruct
others who may use this tool. If someone borrows this tool, make sure they
have these instructions, also.
A
_1_ WARNING: Your router should never be connected to the power source
when you are assembling parts, making adjustments, installing or removing
collets/nuts or cutting bits, cleaning, or when it is not in use. Disconnecting the
router will prevent accidental starting, which could cause serious personal injury.
1. The router motor is attached to the fixed base, and the 1&-in. collet nut is
already installed when you open the package. Carefully lift the router motor
in the fixed base out of the storage/carrying case and place it on a stable,
flat surface.
2.
3.
4.
Lift the plunge base and the D-handle base out of the case and place them
on a flat surface.
Open the parts bag to locate the following:
Edge Guide
• 1/4-in. Collet/Nut
• Collet/Nut wrench
• Power Cord
- 2 Sawdust-Extraction Hoods
• 2 Screws to attach the Sawdust-Extraction Hood to the Plunge Base
• Chip Shield for Plunge Base
• Depth-Adjustment Wrench
Inspect the items carefully to make sure that no breakage or damage has
occurred during shipping. If any of the items mentioned is missing, (refer to
"PARTS LIST" illustration), return the router to your nearest Sears store or
Craftsman outlet to have the router replaced.
28084 Manual Revised 07-0712 Page 11