Leveling Table Supports - Craftsman 113.198251 Operator's Manual

Leveling Table Supports
1o Raise the radial arm until the bottom of
the motor is about 2-1/2 inches above the
saw,
2. Locate four hex head bolts and put a flat
washer on each_
3, Attach a table support to each side of the
saw using the four hex head bolts and flat
washers, (Figure 55 & 55A) Put the bolts
through the center of the enlarged holes in the
table supports so that the supports may slide
up or down as needed.
Table Support
Lockwasher
Nut
Table Support
Screws
Here
_" Flat Washer
Hex Head Bolt
Fig. 55
(0 (L _ Front
Mount Support
Using These Holes
Fig 55A - Hex Head Bolt, Washer; Lockwasher
and Hex Nut
4. Put a lockwasher and hex nut on each bolt
and hand-tighten.
5_ Unlock the bevel lock to release the motor.
Hold onto the motor as you do this.
A'k
CAUTION: The motor is heavy and
can swing down quickly. You can be cut
or injured if the arbor shaft hits you. Hold
the motor when you unlock the bevel lock.
6. Turn the motor' until the arbor shaft is
pointing straight down toward the saw°
(Figure 56)
£
Arbor Wrench
Rear Bolt
Fig. 56
74 Lock the bevel lock to hold the motor in
this position,
8_ Unlock the miter lock and move the arm to
the left as far as it will go (about 50 ° miter).
9. Unlock the rip lock and move the motor
until the arbor shaft is over the rear bolt on
the left table support. (Figure 56)
I0. Mark the point on the table support un-
der the center of the arbor shaft,,
11. Place the handle end of the arbor wrench
over this point and lower the arm until the
arbor shaft is just touching the wrench. The
wrench should slide back and forth with slight
contact_ (Figure 56)
12_ Tighten the bolt under this point using a
1/2 inch wrench.
t3, Move the arm and motor until the arbor
shaft is over the front bolt on the left table
support°
Do not change the elevation of the
arm as you move from point to poinL
(Figure 57)
24