Craftsman 113.198251 Operator's Manual page 38

Antikickback Pawls
F/go 92
Fence
Table
/
12. If the spreader and blade both rest against
the fence, ilo adjustment is needed. (Figure
93-A) Go to step 17, or
If the spreader is in front of the fence but not
touching it (Figure 93-B), go to step 13, or
If the spreader hits the top of the fence
{Figure 93-C), go to step 13.
A - Right
13. Loosen both nuts Oll the spreader using a
1/2 inch wrench.
14. Slide the spreader with your hand until it
is against the fence directly behind the blade.
15. Tighten both nuts using a 1/2 inch
wrench° Do not move the spreader as you
tighten these nuts.
16. Check the blade and spreader again to
make sure that they are both against the
fence. If not, go back to step 13 and repeat°
17. Once the blade and spreader are in line,
raise the &reader up to the guard and tighten
the wing screw to hold it in place.
t8. Unlock the rip lock.
19, Pull the motor" forward so that the blade is
away from the fence and lock the rip lock.
20. Unlock the swivel loclc
21. Turn the motor to the crosscut positon
with the blade and arm perpendicular to the
fence.
22. Lock the swivel locko
- Spreader
TaNe
Saw Blade
B - Wrong
Pawl
Fence_
Table _
!
i -Spreader
Saw Blade
Fig.99 -A&c
C - Wrong
Fence
Table
-Spreader
Saw Blade
38