Electrical Connections; Motor Specifications; Power Supply - Craftsman 113.198251 Operator's Manual

10-inch electronic radial saw with 23" cabinet and 1 door, & with leg set
Table of Contents

Advertisement

E ectrical
Connections
_.'n
i
.....
lU
i
Motor Specifications
The AC motor used in this saw is a capacitor-
start, non-reversible
type having the following
specifications:
Rated H,,P ................................
1.5
Maximum
Developed
HP ..................
2.5
Voltage
.................................
! 20
Amperes
................................
11_5
Hertz (cycles)
.......................
60
Phase
.................................
Single
RPM
...................................
3450
Rotation
of Arbor Shaft
........
C!ockwise
Power Supply
WARNING:
Your saw is wired at
the factory for 120V operation.
Connect
to a 120V, 15-AMP,
branch
circuit and
use a 15-AMP,
time delay fuse or circuit
breaker.
Failure to connect
in this way
can result in injury from
shock or fire.
WARNING:
To avoid shock or fire, if
power cord is worn, cut_ or damaged
in
any way have it replaced
immediately.
Your unit is wired for 120V it has a plug
that looks like the one shown
below. (F_gure
99)
®
3-Prong Plug
Grounding
Prong
Property
Grounded
Outlet
Fig 99 - Plug for Less Than 150V
Your saw must be properly grounded. Not aI1
outlets are properly grounded.
If you are not
sure that your outlet is properly grounded,
have it checked by a qualified electrician.
,
WARNING:
If not properly
grounded
this power
tool can cause
electrical
shock,
particularly
when
used
in damp
locations.
A
AtLWARNING:
If an electrical
shock oc-
curs, your reaction
to the shock may
bring your hands into contact with the
blade.
]his
power tool is equipped
with a 3-
conductor
cord and grounding
type plug listed
by Underwriters'
Laboratories.
The ground
conductor'
has a green .jacket and is attached
to the tooI housing
at one end and to the
ground
prong in the attachment
pIug at the
other' end
This plug requires a mating 3-conductor
grounded type outlet as shown above. If you
have an outlet that is of the two prong type, it
is recommended
that you have a qualified
electrician replace the it with a properly
grounded three prong outlet.
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

113.198211

Table of Contents