Model 113.198211 - Beginning The Cabinet - Craftsman 113.198251 Operator's Manual

4, As you assemble your radial arm saw,
some of the holes in the parts will line up and
others will not, This happens because some
parts are used in other equipment or for other
purposes_ Follow the instructions carefully,,
The figures will show which holes should line
up in each step,
Model 11t3.19821.1
Beginning the Cabinet
The following parts are used in the cabinet
assembly for model t 13_ 198211:
A Right Side Panel .................. 1
B Left Side Panel .................... 1
C Lower Shelf ....................... 1
D Skirt ................................... 2
E Shelf Stiffener ..................... 1
F Corner Bracket ................... 2
G Spacer ....................... 2
H Door° ............................... 1
I Caster ............................. 2
D
t, Turn the shelJ upside down on the floor°
The wide edge should point down, and the
three narrow edges should point up.
(Figure 15)
0 o 0 0
0 0 0 0
Shelf
Corner /j
Brackets f
0 0 0 O0 _
Fig. 15
2. Put a corner bracket in the front corners of
the shelf (Figure 15)
,3. Put two truss head bolts through the shelf
and each corner bracket to hold the brackets
in place,
4o Put a lockwasher and hex nut on each bolt
and tighten with a 7/16 inch wrench or
socket,
5. Put the she!jstiffener on the shelf and line
up the holes. (Figure 16)
F G
Fig, 14 - Cabinet Assembly - 113.198211
Fig° 16
(m
Truss Head Bolt
Lockwasher
Hex Nut
11