Beginning The Cabinet - Craftsman 113.197250 Operator's Manual

11. Push the bevel lock to the left as far as it
will go. (Figure 13D)
12. If there is a 1/16 inch gap or less between
the bevel lock and the left side of the yoke
(and they are not touching), go to step 14, or
Bevel Lock
A Right Side Panel ............... 1
B Left Side Panel ................ 1
C Lower Shelf ................... 1
D Skirt ......................... 2
E Shelf Stiffener ................. 1
F Corner Bracket ................ 2
G Spacer ....................... 2
H Door ......................... 1
I Caster ........................ 2
D
FTg.13D
If the bevel lock touches the left side of the
yoke, unlock the bevel lock and tighten the
locknut on the motor pivot support. Then go
to step 10 and repeat, or
If there is more than 1/16 inch gap between
the bevel lock and the left side of the yoke,
unlock the bevel lock and loosen the locknut
on the motor pivot support. Then go to step
10 and repeat.
13. Repeat steps 10-11 until the bevel lock will
not touch the left side of the yoke, and the gap
is not more than 1/16 inch.
14. I._k the bevel lock.
15. Snap the yoke plug into place. The yoke
plug is in the loose parts bag.
Beginning the Cabinet
MODEL 113.197210
The following parts are used in the cabinet
assembly for model 113.197210:
F G
Fig. 14- Cabinet Assembly - 113.197210
1. Turn the shelf upside down on the floor.
The wide edge should point down, and the
three narrow edges should point up.
(Figure 15)
0 0 0 0
0 0 0 o
Shelf
Corner
Brackets ._
o
o
Fig. 15
2. Put a corner bracket in the front corners of
the shelf. (Figure 15)
12