Using Fabric Watch with SNMP
Introduction
To configure Fabric Watch with SNMP, you must use your SNMP browser. The
instructions that follow provide high-level, basic steps to configure Fabric Watch
with SNMP. Specific tasks may vary from browser to browser.
1. Load the MIB file from the SNMP browser.
2. Enter the atgcfgset command on the switch that you want to configure
3. Configure the switch to give configuration permission to the server. The
4. In your SNMP browser, enter the switch IP address and community.
5. Enter SNMP set commands to configure thresholds.
98
to set the agent on the switch.
server only requires read access to send a trap. The server requires write
access to set a threshold.
Fabric Watch Version 3.1.x/4.1.x User Guide