Segmentation Changes Area Messages; Probable Cause - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Message
Description
Troubleshooting
Message
Description
Troubleshooting
Incom
Message
Description
Troubleshooting

Segmentation Changes Area Messages

Probable Cause

Segmentation changes may occur due to
During E_Port initialization, ports exchange link parameters. Incompatible
parameters result in segmentation. This incompatibility rarely occurs.
Fabric Watch Version 3.1.x/4.1.x User Guide
FW-BELOW, 3, fabricDI000 (Fabric Domain ID) is below low boundary.
current value : <value> DID Change(s). (info)
Explains that the total number of Domain ID changes has fallen below the
low boundary. Provides the new value.
All Domain ID messages are informational. Respond to this message as is
appropriate to the particular policy of the end-user installation.
WARNING EXCEEDED, 4, fabricDI000 (Fabric Domain ID) is exceeded
boundary. current value : <value> DID Change(s). (info)
Explains that the total number of Domain ID changes has risen above or
fallen below the acceptable range. Provides the new value.
All Domain ID messages are informational. Respond to this message as is
appropriate to the particular policy of the end-user installation.
FW-INBETWEEN, 3, fabricDI000 (Fabric Domain ID) is between high &
low boundaries. current value : <value> DID Change(s). (info)
Explains that the total number of Domain ID changes has changed from a
value outside of the acceptable range to a value within the acceptable range.
Provides the new value.
All Domain ID messages are informational. Respond to this message as is
appropriate to the particular policy of the end-user installation.
Zone conflicts.
Incompatible link parameters.
Domain conflicts.
Segmentation of the principal link between two switches.
Responding to Fabric Watch Messages
145