Sound Adjustments; Operating Procedure; Adjustingthetone--Bass, Treble; Adjusting The Subwoofer Output Ievei--Subwfr - JVC RX-ES1SL Instructions Manual

Sound adjustments
When operating the receiver using the remote control, always set the mode selector to AUDIOF1"V/VCR/DBS.
Operating procedure
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step f again.
1 Press ADJUST.
MULTi JOG now works for the sound adjustment.
2 Turn MULTI JOG until the setting item you want
to set appears on the display, then press SET.
• As you turn MULTI JOG, the indication changes as follows:
.... i.-! L.i :-. :-_ i'_ 2D
Adjustingthetone--BASS, TREBLE
You can adjust the bass and treble sounds to your preference.
• You have to make these adjustments for each source.
BASS*: To adjust the bass (from -10 dB to +f 0 dB).
TREBLE*: To adjust the treble (from -f 0 dB to +t0 dB).
* "0" is the initial setting.
When usingthe remote control:
1 Press TONE.
2 Press BASS _]_/_ or
TREBLE _]_/_ to adjust the
sound level (from -10 dB to
+10 dB).
When you use the 10 keys to operate your target source after tone
adjustments, press the corresponding source selecting button first so
that the fO keys work for your target source.
3 Turn MULTI JOG to adjust the item selected in
step 2, then press SET.
Your setting is stored.
I II ,% : .L::.:_
Ex.: When selecting "+10 (dB)" for "BASS".
Adjustingthe subwoofer outputlevel
1SUBWFR
You can adjust the eubwoofer output level if you have connected a
eubwoofer and set the subwoofer information correctly--"USE" for the
Quick Setup or "YES*' for the Manual Setup (see pages 16 and f 7).
• You have to make this adjustment for each source.
SUBWFR*: To adjust the subwoofer output level (from -10 dB to
+tO dB).
* "0" is the initial setting.
When usingthe remote control:
Press SUBWFR +/- to adjust the
subwooter output level (from -10 dB
to +10 dB).
CONTINUED ONTHENEXTPAGE
21