Table of Contents
Advertisement
Sound adjustments
You can make sound adjustment to your preference after
completing basic setting.
Basic adjustment items
You can adjust the following items. See pages in parentheses for details.
• You cannot select the items which is not available with the current setting.
• The name of the item shown below is the on-screen display indication and the name in parentheses is the display indication.
SUBWOOFER LEVEL (SUBWFR LVL)
Adjust the subwoofer output level. (29)
FRONT L LEVEL (FRONT L LVL)
Adjust the left front speaker output level. (29)
FRONT R LEVEL (FRONT R LVL)
Adjust the right front speaker output level. (29)
CENTER LEVEL (CENTER LVL)
Adjust the center speaker output level. (29)
SURR. L LEVEL (SURR L LVL)
Adjust the left surround speaker output level. (29)
SURR. R LEVEL (SURR R LVL)
Adjust the right surround speaker output level. (29)
DIGITAL EQ 63Hz (D EQ 63Hz)*
DIGITAL EQ 250Hz (D EQ 250Hz)*
DIGITAL EQ 1kHz (D EQ 1kHz)*
DIGITAL EQ 4kHz (D EQ 4kHz)*
DIGITAL EQ 16kHz (D EQ 16kHz)*
Adjust the equalization pattern of each band. (30)
* If you have used Smart Surround Setup on pages 16 and 17, these settings are not required.
NOTE
Adjusting the items may blur the picture when you view the playback picture through RGB connection. If it occurs, set "SUPERIMPOSE"
to "SUPERIMPOSE: ON" (see page 25).
Operation through on-screen display menus
You can make adjustments to the basic settings easily by using the on-screen display menus.
Menu operation buttons
On the front panel:
Button / JOG
To do
ADJUST button show adjustment item previously selected.
SET button
move to the selected menu or return to the
previous ADJUST MENU.
MULTI JOG
• select a menu or an item.
• change a setting.
26
Items and to do
BASS BOOST (BASS BOOST)
Boost the bass level. (30)
SUBWFR PHASE (SBWFR PHASE)
Select the subwoofer sound phase. (30)
INPUT ATT (INPUT ATT)
Attenuate the input level of analogue source. (30)
EFFECT (EFFECT)
Adjust the effect level. (31)
PANORAMA (PANORAMA)
Add wraparound sound effect with side-wall image. (31)
CENTER TONE (CENTER TONE)
Make the center tone soft or sharp. (31)
CNTR ALIGNMENT (CNTR ALIGN)
Align the vertical localization of the center channel. (31)
From the remote control:
Button
To do
MENU button show "TOP MENU."
5 / ∞ buttons select a menu or an item.
SET button
move to the selected menu or return to the
previous ADJUST MENU.
2 / 3 buttons change a setting.
When operating the receiver
using the remote control,
set the mode selector to
"AUDIO/TV/VCR/STB."
Advertisement
Table of Contents
