Adjusting The Frontspeakersoutput Balance--Bal; Reinforcing The Bass--B.boost; Attenuating The Inputsignai--Att - JVC RX-ES1SL Instructions Manual

Sound adjustments
Setting
the subwoofer audio
position
When a stereo source is played back, the subwoofer sound is
reinforced compared to the sound from a multi-channel source.
Once you have set the subwoofer audio position, the subwoofer
output level is decreased by the selected value when a stereo source
is played back. The A (audio).POSITION indicator lights up when this
function is activated.
• You have to make this adjustment for each source.
From the remote control ONLY:
Press A.POSITION repeatedly to
select the subwoofer audio position
level from "-2 (dB)," "-4 (dB)," and "-6
(dB):'
The smaller the number becomes, the more the
level decreases automatically when listening in
stereo.
• If no adjustment is required, select "OFF" (initial
setting).
Reinforcing the bass--B.BOOST
You can boost the bass level--Bass Boost.
• You have to make these adjustments for each source.
ON: Select to boost the bass level (Bass Boost).
The BASS BOOST indicator lights up on the display.
OFF*: Select to deactivate Bass Boost.
* Initial setting
This function affects the sound coming out only through the front
speakers.
When using the remote control:
Press BASS BOOST.
• Each time you press the button, Bass Boost
turns on and off alternately.
• The maximum subwoofer output level is -10 dB.
Ex.:
When setting the subwoofer output level to "-8 (dB)" and the
subwoofer audio position to "-4 (dB)," the subwoofer output level
when listening in stereo will be -10 dB.
• This function does not take effect when activating a Surround
mode.
Adjusting the frontspeakersoutput
balance--BAL
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speakers output balance.
• You have to make this adjustment for each source.
• You cannot use the remote control for this setting.
BAL*: To adjust the front speakers balance.
• "CENTER" to "L-21": Decrease the left channel output.
• "CENTER" to "R-21": Decrease the right channel
output.
* "CENTER" is the initial setting.
Attenuating the inputsignaI--ATT
When the input level of analog source is too high, the sound will be
distorted. If this happens, you need to attenuate the input signal level
to prevent the sound distortion.
• You have to make this adjustment for each analog source.
• You cannot use the remote control for this setting.
ON: Select to attenuate the input signal level.
The INPUT ATT indicator lights up on the display.
NORMAL*: Select to deactivate attenuation.
* Initial setting
22