Wiring Diagrams - HAMPTON BAY Hampton H35-NG2 Owners & Installation Manual

INSTALLATION
If any of the original wires as supplied with the
appliance must be replaced, it must be replaced
o
with CSA type SEW (200 C) or its equivalent.
This heater does not require a 120V A.C.
supply for operation. In case of a power failure,
the burner switch and the optional remote control/
thermostat will continue to operate. However, a
120V A.C. power supply is needed for the fan/
blower operation.
NATURAL GAS
For
38

WIRING DIAGRAMS

Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
CAUTION: Label all wires prior
to disconnection when servicing
controls. Wiring errors can
cause improper and dangerous
operation.
NOT
Units and Units
WARNING: Electrical Grounding
This appliance is equipped with a
three pronged (grounding) plug for
your protection against shock hazard
and should be plugged directly into
a properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this plug.
Equipped with DC Spark Boxes
Hampton® H35-2 Direct Vent Freestanding Gas Stove
Instructions