HAMPTON BAY Hampton H35-NG2 Owners & Installation Manual page 33

5) Locate the ground lug at the receptacle
box, left of the unit.
6) Connect one end of the supplied green
ground wire to the lug with the nut and
washer from the kit.
Ground
wire from
kit
7) Install the 1/2" bushing to the heat
shield.
8) Run the other end of the ground wire
and DC spark generator wires through
the bushing on the heat shield.
Heat Shield
Hampton® H35-2 Direct Vent Freestanding Gas Stove
9) Plug the DC spark generator wires to the
DC Sparker.
10) Connect the ground wire to the DC
Sparker mounting bracket.
11) Install the supplied battery into the DC
Sparker Box by opening the battery
compartment.
NOTE: The battery in the DC Sparker
Box will need to be replaced annually.
Battery
Compartment
INSTALLATION
12) Mount the heat shield to the DC Sparker.
Secure into place with the velcro, which
is provided in the kit.
13) Find a location which is not too hot and
is easy to reach for changing the battery.
14) Tie up the loose wire with the wire clip.
15) Check for gas leaks.
16) Check inlet and outlet pressures.
17) Check operation of fl ame control.
18) Check for proper fl ame appearance and
glow on logs.
Installer Notice:
These instructions must
be left with the appliance.
33