Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are
replaced. Broken logs can interfere with the pilot operation.
The gas log kit (Part # 512-930) contains the following:
a) 02-49
Rear Log
b) 02-55
Middle Left Log
c) 02-50
Front Left Log
d) 02-53
Center Left Log
e) 02-51
Front Bottom Log
f) 02-54
Center Right Log
g) 02-52
Middle Right Log
h) 902-156
Embers
i) 902-179/21
Vermiculite
j) 946-669
Platinum Embers (
The "02" refer numbers (i.e. 02-49) are
molded into the rear of each log.
NOTE: If installing the optional Brick Panels, install prior
to log installation.
1)
Carefully remove the logs from the box and unwrap them.
The logs are fragile, handle with care - do not force into
position.
2)
Sprinkle the vermiculite around the fi rebox base.
FPI P36-4 Zero Clearance Direct Vent Gas Fireplace
LOG SET INSTALLATION
supplied w/packaged manual)
Vermiculite
3)
Place Log 02-49 on the rear log support pins with the fl at
side to the back.
4)
Place Log 02-51 on the front right side of the burner. Push
the back of the log against the 2 brackets with the notch
on the bottom right side of the log fi tting into the right side
of the grate.
Bracket
02-49
INSTALLATION
02-49
02-51
Notch
Bracket
02-51
39