HP StorageWorks 8000 - NAS Command Reference Manual page 73

failbackClusterPackag
Stops the package on the current node and starts it up on the Primary owning node.
I
InParam[0] = Package name
setClusterPackageEnabled
Enables or disables the package from running on the given node. If a package is disabled from
running on an alternate node, then it cannot failover to that node.
I InParam[0] = Package name
I InParam[1] = Node name
I InParam[2] = T (enabled) or F (disabled)
getClusterPackageNameList
Gets the complete list of package names that have been created on the cluster, whether running
or not.
I OutParam[0:N] = List of package names
getClusterPackagePrimaryOwner
Gets from the registry, the name of the node that owns the package.
I
InParam[0] = Package name
I OutParam[0] = Primary owning node of the package
setClusterPackagePrimaryOwner
Required. Sets in the registry, the name of the node that owns the package. Running Required
Required Required
'startClusterPackage startClusterPackage startClusterPackage packageName' without a nodeName argument, starts the package on startClusterPackage
the primary owning node.
I
InParam[0] = Package name
I InParam[1] = Node name
getClusterPackageCurrentOwner
Gets the name of the node that is currently running the package.
I InParam[0] = Package name
I
OutParam[0] = Node name
getClusterPackageAdoptiveNodeList
Gets a list of the nodes that are allowed to run the package in a failover situation.
I InParam[0] = Package name
I OutParam[0:N] = Node name list
getClusterPackageVirtualIpAddressList
Gets from the registry, the VirtualIpAddress/Subnet values served by this package.
I InParam[0] = Package name
I OutParam[0:N] = VirtualIPAddress/Subnet list
Command Reference 71