HP StorageWorks 8000 - NAS Command Reference Manual page 10
Hp surestore nas 8000 command reference manual
Hide thumbs
Also See for StorageWorks 8000 - NAS:
- User manual (268 pages) ,
- Overview (59 pages) ,
- Installation and user manual (42 pages)
Table of Contents
Advertisement
8
Command Reference
getNetworkCardDhcpEnabled
Identifies whether the specified NIC is DHCP enabled.
When DHCP is enabled, NIC configuration occurs automatically. Depending on your
configuration, the DHCP server provides any or all of the following parameters: IP Address,
Subnet Mask, Gateway Address, Broadcast Address.
I
inParam[0] = Network card name
I
outParam[0] = T (Enabled) or F (Disabled)
setNetworkCardDhcpEnabled
Enables or disables DHCP for the specified NIC. If DHCP is disabled, the NIC IP address must be
manually defined.
I
inParam[0] = Network card name
I
inParam[1] = T (Enable) or F (Disable)
getNetworkCardEnabled
Identifies whether the specified NIC is enabled.
I
inParam[0] = Network card name
I
outParam[0] = T (Enabled) or F (Disabled)
getNetworkCardGatewayAddress
Returns the gateway address for the specified NIC.
I
inParam[0] = Network card name
I
outParam[0] = Gateway address
setNetworkCardGatewayAddress
Sets the gateway address for the specified NIC.
I
inParam[0] = Network card name
I
inParam[1] = Gateway address
getNetworkCardInterfaceName
Returns the name for the specified NIC.
I
InParam[0] = Network card (NIC)
I
OutParam[0] = Name
getNetworkCardIpAddress
Returns the IP address for the specified NIC.
I
inParam[0] = Network card
I
outParam[0] = IP address
Advertisement
Chapters
Table of Contents
