Table of Contents
Advertisement
Problem Solving
Problems when projection starts
No power supplied
Check
Did you press the [t] button?
Are the indicators switched off?
Do the indicators turn on and off when the power cable is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If
Is the Control Panel Lock set to Full Lock?
Is the correct setting for the remote receiver selected?
Other problems
No sound can be heard or the sound is faint
Check
Is the audio source connected correctly?
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
No sound can be heard from the microphone
Check
Is the microphone connected correctly?
Press the [t] button to turn the power on.
The power cable is not connected correctly or power is not being supplied normally.
Disconnect and then reconnect the power cable. s Quick Start Guide
Check that your electrical outlet or power source is functioning correctly.
this does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and
contact your local dealer or the nearest address provided in the Support and Service Guide. s
Contact List
Press the [t] button on the Remote Control. If you do not want to use Control Panel Lock, change the setting to
Off. s Settings Menu - Control Panel Lock
Check the Remote Receiver from the Configuration Menu. s Settings Menu - Remote Receiver
Disconnect the cable from the Audio-L/R input port, and then reconnect the cable.
Adjust the volume so that sound can be heard. s
Press the [A/V Mute] button on the Remote Control to cancel A/V Mute. s
When using a commercially available audio cable, make sure it is labeled "No resistance".
Disconnect the cable from the Mic Input Port, and then reconnect the cable.
Remedy
p.31
Remedy
p.37
s Quick Start Guide
p.19
Remedy
63
Epson Projector
p.37
Advertisement
Table of Contents
