Table of Contents
Advertisement
List of Functions
Sub Menu
Operation
Standby Mode
Standby Microphone
USB Type B
Language
Reset
*1 When User's Logo Protect is set to On in Password Protect, settings relating to User's Logo cannot be changed. You can make changes after setting "User's Logo
Protect" to "Off". s
p.29
*2 A commercially available serial W IP conversion adapter and connector cable are necessary to allow EB-824 owner's to use EMP Monitor. For supported products,
see http://www.epson.com.
*3 If Power On Protect in Password Protect is On, mic input is not possible even when Standby Microphone is set to On.
*4 Except for "High Altitude Mode".
Direct Power On: You can set whether or not (On/Off) to enable Direct Power On.
When it is set to On and the power cable is plugged in, be aware that the projector turns on automatically in case such as a power
outage is restored.
Sleep Mode: When set to On, this automatically stops projection when no image signal is being input and no operations are carried
out.
Sleep Mode Timer: When Sleep Mode is set to On, you can set the time before the projector automatically turns off within a range
of 1 to 30 minutes.
Lens Cover Timer: When set to On, this turns off the power automatically 30 minutes after the A/V mute slide knob is closed.
Lens Cover Timer is set to On at the time of purchase.
High Altitude Mode: Set to On when using the projector above an altitude of 1500 m.
You can use the following functions even when the projector is in standby mode if this is set to Communication On.
• Monitor and control the status of the projector over the network.
• The Mic Input function outputs audio from the projector's speaker when a mic is connected to the Mic Input Port.
This is also enabled if this setting is set to Communication On and Standby Microphone is set to On.
g
You can use SNMP
to monitor and control the status of the projector over the network, or by using the "EMP Monitor"
*2
software
supplied with this product.
(Only possible when the Standby Mode mentioned above is set to Communication On)
When Standby Mode is set to Communication On, set whether mic Input is enabled (On) or disabled (Off).
Set to USB Display when the projector and a computer are connected by a USB cable and computer images are projected. s Quick
Start Guide
Set to Wireless Mouse when the mouse pointer is to be operated by the Remote Control. s
You can set the Language for message displays.
*1
You can reset Display
and Operation
To return all menu items to their default settings, see s
Function
*4
from the Extended menu to their default settings.
p.52
*3
p.27
40
Advertisement
Table of Contents
