Table of Contents
Advertisement
Problem Solving
Check
Is the Mic Input Volume turned down too low?
The Remote Control does not work
Check
Is the Remote Control light-emitting area pointing towards the
Remote receiver on the projector when it is operated?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining
onto the Remote Receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s
I want to change the language for messages and menus
Check
Change the Language setting.
Mail is not received even if a problem occurs in the projector (EB-826W/825/85)
Check
Is Standby Mode set to Communication On?
Did a fatal abnormality occur and the projector come to a sudden
stop?
Is power being supplied to the projector?
Is Mail Notification function set correctly in the Configuration
Menu?
Adjust the Mic Input Volume so that sound can be heard. s Settings Menu - Mic Input Volume
Point the remote control towards the Remote Receiver.
Operating range s Quick Start Guide
The operating range for the remote control is about 6 m. s Quick Start Guide
Set the projector up in a location where strong light does not shine onto the Remote Receiver. Or set the remote
receiver to Off from Remote Receiver in the Configuration Menu. s Settings Menu - Remote Receiver
Check the Remote Receiver from the Configuration Menu. s Settings Menu - Remote Receiver
Adjust the Language setting from the Configuration Menu. s
To use the Mail Notification function when the projector is in standby, set Communication On in Standby Mode
from the Configuration Menu. s Extended Menu - Standby Mode
When the projector comes to a sudden stop, e-mail cannot be sent.
If the abnormal state continues, contact your local dealer or the nearest address provided in the Support and Service
Guide. s
Epson Projector Contact List
Check that your electrical outlet or power source is functioning correctly.
Mail notification of problems is sent according to the Mail settings in the Configuration Menu. Check if it is set correctly.
s Network menu - Mail menu
p.48
Remedy
Remedy
Remedy
p.39
Remedy
p.39
64
p.37
p.37
p.37
p.68
Advertisement
Table of Contents
