Craftsman 139.53990DS Owner's Manual page 24

ONE-PIECE
D OORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Metal Doors: Drill 3/16" pilot holes and fasten the
bracket with the 1/4"-14x5/8" self-threading screws
provided.
• Wood Doors: Drill 5/16" holes and use 5/16"x2"
carriage bolts, lock washers and nuts (not
provided) or
5/16"x1-1/2" lag screws (not provided) depending
on
your installation needs.
NOTE:The door bracket may be installed on the top
edge of the door if required for your installation. (Re-
fer to the dotted line optional placement drawing.)
Header Wall
2x4 Support
Door
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline of
Garage Door
-- Finished Ceiling --
Door
Bracket_
HORIZONTAL AND VERTICAL
REINFORCEMENT IS NEEDED
FOR LIGHTWEIGHT GARAGE
DOORS (FIBERGLASS,
ALUMINUM, STEEL, DOORS
WITH GLASS PANEL, ETC.).
NOT PROVIDED)
For a door with no exposed framing,
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.
HARDWARE SHOWN
ACTUAL SIZE
Self-Threading Screw
1/4"-14x5/8"
_ elf-Threading
Screw
' 1/4"- 14x5/8"
Top of Door
(Inside Garage)
Edge
of Door
Optional
Placement
METAL DOOR
Nut
5/16"-18 _
¢
Lock
_ Washer
, 5/16"
i
Top of Door
Garage)
Top Edge
of Door
Placement
__ arriage Bolt
5/16"x2"
(Not Provided)
WOOD DOOR
24