Xerox DocuPrint N2025 System Administrator Manual page 55

Table 1.13 PCL Menu Functions (continued)
Menu Item and Function
Form Length
Set the default text length (number of
lines on a page) used in PCL.
The available values are:
5 - 128
(60* when Defaults = Inches)
(64* when Defaults = Millimeters)
Form Length is automatically adjusted
when Paper Size is changed. The
Form Length is recalculated using the
formula: Form Length = ((page length
in inches - 1 inch) * 6).
The Form Length value changes
incrementally by 1 each time either
Value Up or Value Down is pressed.
Holding down Value Up or Value
Down causes continuous scrolling
through the Form Length values.
The value of this setting after
performing a Factory Reset depends
on the value of the Default units
(inches, millimeters).
Keystrokes
1. Press Menu Up or Menu
Down until you see:
2. Press Item Up or Item Down
until you see:
3. Press Value Up or Value Down
until you see:
4. Press Enter. You will see:
5. Press Online. You will see:
Chapter 1: Configuring the Printer
Using the Menu System
Display Reads
Menus
PCL Menu
PCL Menu
Form Length
Form Length
New Value
PCL Menu
Form Length
Ready
Table 1.13 Page 5 of 6
=
1-39