Xerox DocuPrint N2025 System Administrator Manual page 192

Control Panel Messages
Table 5.1 Control Panel Messages (continued)
Message
Tray 2/3 Failure
Power Off/On
Tray 3 Failure
Power Off/On
Tray 3 Jam-
Open Tray 3
Tray 2 Lifting
or
Tray 3 Lifting
Tray n Empty
Waiting...
Warming Up...
5-14 System Administrator Guide
Explanation/Corrective Action
Tray 2 or Tray 3 when installed with a 500 sheet feeder has failed. Printing
using these trays cannot resume. Power off the printer. Reinstall Tray 2 and
Tray 3 500 sheet feeders. Then power on the printer. If the problem
persists, contact your Customer Service Center.
Tray 3 when installed with a 2000 sheet feeder has failed. Power off and
power on the printer. If the problem persists, contact your Customer
Service Center.
A paper jam has occurred at or before the input sensor when feeding
paper from Tray 3.
• If Tray 3 is a 500 sheet feeder, remove Tray 3 from the printer.
• If Tray 3 is a 2,000 sheet feeder, open the feeder's paper tray
Then refer back to the Control Panel for further messages.
The indicated tray has been refilled, is rising into position and will be soon
ready for printing.
The indicated tray is empty and should be refilled. The job has not stopped
printing yet because the printer has switched to another input tray that
contains paper.
There are no more data in the data stream and the job (for PostScript) or
the page (for PCL) is incomplete.
Please wait while the printer warms up.
Table 5.1 Page 10 of 10