Interface Card
2
3
6-46
System Administrator Guide
7
Insert the card into the controller board as illustrated.
A
B
C
8
Secure the card with the screws from Step 6.
9
Replace the controller board's access cover by (1) pushing
it in at the top, (2) sliding it down, and (3) aligning it with
the screw holes.
1
Align the connector on the rear underside of the card
with the matching receptacle in the controller board.
Align the screw receptacles on the front edge of the
card with the screw slots where you removed the cover
plate.
Press the card into the receptacle.