Xerox DocuPrint N2025 System Administrator Manual page 141

Table 1.36 Custom Paper Size Examples.
Custom Desired
Paper Size Input Source
8 x 10 in. Tray 1
6 x 7 in. multi bypass
feeder
8.5 x 11 in. Tray 1
Short Edge
Feed (SEF)
1. In the application, format the page for Letter size paper, setting the
margins to correctly position the image on 8 x 10 in. paper if
overlaid by Letter size paper.
2. Load the 8 x 10 paper in Tray 1.
3. Set the Tray Menu Tray 1 Mode item to Custom.
4. Set the Custom Size item to Letter(8.5x11).
5. Set the Tray Sequence item to a value that does not include Tray 1
(or set to Off).
6. Request Tray 1 as the paper source and send the print job.
1. In the application, format the page for Letter size paper, setting the
margins to correctly position the image on 6 x 7 in. paper if overlaid
by Letter size paper.
2. Load the 6 x 7 in paper in Tray 1.
3. Set the Tray Menu MBF Size item to Custom.
4. Set the Custom Size item to Letter (8.5x11").
5. Set the Tray Sequence item to a value that does not include MBF
(or set to Off).
6. Request MBF as the paper source and send the print job.
1. In the application, format the page for Folio size paper (because Folio
is a short-edge feed size on this printer), setting the margins to
correctly position the image on the 11 inches to be used by this
paper.
2. Load the 8.5 x 11" paper into Tray 1 in the SEF direction. This
requires a Ledger/A3 size tray. The paper length guide will be set to
11 inches, rather than the width guide. (Set the width guide to 8.5".)
3. Set the Tray Menu Tray 1 Mode to Custom.
4. Set the Custom Size to Folio (8.5 x13").
5. Set the Tray Sequence item to value that does not include Tray 1 (or
set to Off).
6. Request Tray 1 as the paper source and send the print job.
Chapter 1: Configuring the Printer
Configuring Custom Paper Sizes
Required Steps
1-125