Xerox DocuPrint N2025 System Administrator Manual page 185

Table 5.1 Control Panel Messages (continued)
Message
Flushing
Job name
Format Failed
Disk Locked
Fuser Failure
Power Off/On
Init Failed
Disk Locked
Initializing
Initializing...
Flash Memory
Insert MBF
Insert Tray 1
Explanation/Corrective Action
The printer has discovered a fatal error in a print job and is flushing the
remainder of that job.
The printer cannot format the disk because the disk has been locked via a
PJL or SNMP command.
The fuser assembly has failed or is not installed. Printing cannot resume.
Power off and power on the printer. If the problem persists, contact your
Customer Service Center.
The printer cannot put the disk in factory default condition because an
attempt has been made to initialize the disk after it has been locked via a
PJL or SNMP command.
Please wait until the printer completes powering up and initializing to
print.
The printer is initializing the flash memory.
The printer cannot feed from the multi bypass feeder because it is not set
normally or is not in position. Insert the multi bypass feeder tray to resume
printing.
The printer cannot feed from Tray 1 because the tray is open or removed.
Reinstall/insert the tray to resume printing.
Control Panel Messages
Table 5.1 Page 3 of 10
Chapter 5: Troubleshooting 5-7