Kyocera TASKalfa 3500i Operation Manual page 315

Use the procedure below to select the default Prevent Bleed(Send/Store).
1
Press the System Menu key.
2
Press [Common Settings], [
Store).
3
Set the default Prevent Bleed(Send/Store).
4
Press [OK].
Zoom
Select the enlarged/reduced default settings when paper size/sending size is changed after the originals are set.
The available default settings are shown below.
Item
100%
Auto
Use the procedure below to select the default zoom setting.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Select the default zoom setting.
4
Press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
Input units
Inch
Metric
NOTE:
Refer to page 4-18 and page 6-26 for Border Erase.
Use the procedure below to set the default border erase width.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Press [+] or [–] for the Border and Gutter width to erase.
You can use the numeric keys to enter the number directly.
4
Press [OK].
], [Next] of Function Defaults, [
Copy (send/save) at actual size (100%).
Automatically reduce or enlarge the originals to match the paper
size/ sending size.
], [Next] of Function Defaults, [
0 to 2" (in 0.01" increments)
0 mm to 50 mm (in 1 mm increments)
], [Next] of Function Defaults, [
9-21
Default Setting (System Menu)
] and then [Change] of Prevent Bleed(Send/
Description
] three times and then [Change] of Zoom.
Range
] and then [Change] of Border Erase Default.
9