Kyocera TASKalfa 3500i Operation Manual page 303

For Custom 1-8, settings for duplex printing and media type name can be changed.
Item
Duplex Prohibit
Permit
Name
Use the procedure below to set the paper weight.
1
Press the System Menu key.
2
Press [Common Settings], [Next] of Original / Paper Settings and then [Next] of Media Type Setting.
3
Press [Next] for the media type whose weight you want to change.
4
Press [Change] of Paper Weight.
5
Select the weight and press [OK].
The previous screen reappears.
6
Press [Close].
7
To change the duplex printing settings for Custom 1 (-8), press [Next] of Custom 1(-8) and then [Change]
of Duplex. Select [Prohibit] or [Permit] and press [OK].
The previous screen reappears.
8
Press [Close].
9
To change the name for Custom 1(-8), press [Next] of Custom 1(-8) and then [Change] of Name. Enter the
name and press [OK].
NOTE:
Refer to the Character Entry Method on page Appendix-9 for details on entering characters.
Default Paper Source
Select the default paper source from Cassette 1-5 and Multi Purpose Tray.
NOTE:
[Cassette 3] to [Cassette 5] are displayed when the following options are installed.
[Cassette 3]: When a paper feeder (500-sheet x 2) or large capacity paper feeder (1500-sheet x 2) is installed
[Cassette 4]: When a paper feeder (500-sheet x 2) or large capacity paper feeder (1,500-sheet x 2) is installed
[Cassette 5]: When a side feeder (3,000-sheet) is installed
Description
Duplex printing not allowed.
Duplex printing allowed.
Change names for Custom 1-8. Names should be not more
than 15 characters. Selecting media type at multi purpose
tray, the name after change will be displayed.
9-9
Default Setting (System Menu)
9