Adjusting The Top-Of-Form Position - Epson FX-1180+ User Manual

Note:
The printer has a minimum and a maximum tear-off position. If
you try to adjust the tear-off position beyond these limits, the
printer beeps and stops moving the paper.
4. Tear off the printed pages.
5. Press the Pause button to turn off Micro Adjust mode.
When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and begins printing.

Adjusting the top-of-form position

The top-of-form position is the position on the page where the
printer starts printing. If your printing appears too high or low
on the page, you can use the Micro Adjust function to adjust the
top-of-form position, as described below. Your top-of-form
position setting remains in effect until you change it, even if you
turn off the printer.
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
1. Make sure the printer is turned on.
2. Load paper. (If the tractor is in a push position, press the
Load/Eject button to advance continuous paper to the
current top-of-form position.) If necessary, lift up the printer
cover so you can see the paper position.
3. Hold down the Pause button for three seconds. The Pause
light flashes and the printer enters the Micro Adjust mode.
Paper Handling
2-29