Epson FX-1180+ User Manual page 29

5. Slide the left sprocket approximately 12 mm (0.5 inch) from
the far left position and push the blue lever back to lock it in
place. Then slide the right sprocket to match the width of
your paper, but do not lock it. Move the center support
midway between the two sprockets.
The triangle mark on top of the printer indicates the point
furthest to the left where printing can begin.
6. Make sure your paper has a clean, straight edge. Then open
both sprocket covers and fit the first four holes of the paper,
with the printable side down, over the tractor pins.
7. Close the sprocket covers. Then slide the right sprocket to
remove any slack in the paper and lock it in place by
pushing the blue lock lever down.
Paper Handling
2-7